• +380660630658
    order@dredgers.com.ua
jet suction dredger 1600/25, 300 kW, Diesel, for san minig

The DRW-1600/50 dredger and the GRAT 1600/25 pump is designed for use in mining and processing plants, mining and metallurgical plants, thermal power plants, cement plants, diamond mining and gold mining enterprises, technological lines for crushing, mineral processing and similar industries.

Economic indicators

Provided that the length of the pipeline is 200 meters, and the usual geodetic elevator does not exceed 5 meters, this model nominally produces 240 cubic meters per hour or 2,400 cubic meters per 10 hours of operation.The density of sand is 1.3 tons per cubic meter, weight The extracted sand is 3120 tons. The cost of extracting 3120 tons of sand will be 2000 kWh in 10 hours. The nominal consumption of diesel fuel for 10 hours of operation is 2000 kW x 0.226 l/kW = 452 liters. From this calculation we conclude: To extract 3120 tons of sand, 452 liters of diesel fuel is needed. The cost of producing one ton of sand is 452 liters/3120 tons = 0.145 liters per ton.

General characteristics

Productivity1600m³/h
The height of the water column25m
Productivity dry residue (nominal)240m³/h
Productivity dry residue (max)480m³/h
Power pump for pumping pulp200kW
Powerpoint290kW
Pulp transport length (nominal)400mm
The depth of the development (minimum)0,4m
The depth of the development (maximum)12m
Diameter solids (max)200mm
Diameter pressurized slurry pipeline350mm
Area of useRiver 

Specifications

The length of the dredger20m
The width of the dredge2.4m
Overall width with pontoons8m
The height of the dredger4m
Weight dredger18ton
Internal supply12V
Outdoor supply12V
Onboard power supply12/24V

Installed Hardware

Engine 300 kW (specific consumption of diesel fuel 200 g/kWh)1pcs
Pump GRT-900/67*1pcs
Active milling cutter (increased productivity for light soil)1pcs
Auxiliary pump (ejector) 33 m/cube per hour feed at a head of 70 m1pcs
Reversible propeller 35 kW (dredger drive drive)2pcs
Hydraulic motion control1pcs
Hydraulic cylinder lifting main suction pipe2pcs
Anchor piles (length 8 meters)2pcs
Fixing of the dredger at the work site of the anchor, hydraulic winches3pcs
Anchors3pcs
The drive of the main pump GRT 1600/25 (hydraulic motor)1pcs
Drive of a milling cutter (hydraulic motor)1pcs
Floating slurry pipeline D-500 mm100m
Auxiliary crane-beam1pcs
Fuel tank 2000 liters1pcs
Technical water tank 1000 liters1pcs
The battery (200 А/h)2pcs

* – Pump GRT – centrifugal, horizontal, cantilever, single-stage, impeller with axial supply of hydraulic mixtures, are used for pumping highly abrasive slurries with pH 6-12, density up to 2200 kg/m3, temperature from +5 to +70 ° C, with solids content not more than 40% by volume, average size 6-12 mm and microhardness up to 11000 MPa. “GR”-pump type (ground with an axial inlet), “T”-accurate part with internal casing, water productivity 900 m3/hour, 67 water head meters.

Download booklet